SYNCWORLD  |   INVESTORS  |   PRESS  |   PARTNERS  |   HOW TO BUY  |   SUBSCRIBE
 
Home | Resources | Compliance & Certifications | Leap Second Certification

Leap Second Certification

The International Earth Rotation and Reference Systems Service (IERS), the organization responsible for measuring the relationship between UTC (Coordinated Universal Time) and the rate of Earth’s rotation, sent out Bulletin C36 announcing that a positive leap second would be introduced at the end of the day on June 30, 2012. 
 
The leap second insertion increases the length of the last minute of the UTC day to 61 seconds. The sequence of dates of the UTC second markers shall be:

  • 2012 June 30, 23h 59m 59s
  • 2012 June 30, 23h 59m 60s
  • 2012 July 1, 0h 0m 0s

Reason for the Leap Second
Until 1967 the base unit for time keeping, the second, was defined based on the earth’s rotation around the sun: one second was equal to 1/86400 of a mean solar day. The duration of the earth’s orbit around the sun varies year after year and thus the definition of a second based on the earth’s rotation could also theoretically change year after year. This definition of a second was eventually found to not provide adequate precision for the scientific community.

By 1967, the world’s timekeepers decided to redefine a second to be based on atomic principles, which are much more accurate than the earth’s rotation around the sun and are much easier to reproduce with a high level of precision. From that point on, a second was defined as:

9,192,631,770 periods of the radiation corresponding to the transition between the two hyperfine levels of the ground state of the cesium 133 atom.

With the definition of a second now a function of atomic properties the world’s timekeepers needed a way to add or remove seconds in order to keep the world’s clocks in sync with the earth’s rotation. The addition or removal of seconds is known as a leap second.

Leap seconds don’t happen every year but rather only when the difference between the earth’s atomic clocks (UTC) and the mean solar time (UT1) approaches 0.9 seconds. The last leap second was added on December 31, 2008. 
 
The Handling of Leap Seconds by Symmetricom
For the 2012 leap second insertion, Symmetricom has again tested simulations on a sample of its key products.  Refer to Field Service Bulletin 098-40621-69 in Services & Support, Online Support, under Technical Documents (you will need to use your Symmetricom user ID and password to access the Field Service Bulletin).

For additional Support information on all Symmetricom products including Technical Documentation, Field Service Bulletins, Product Change Notices, Product Manuals, System Release Notices and Product Discontinuance Bulletins, please refer to the Technical Documentation Section of the website. 

 
PRODUCTS
GPS Solutions
Time & Frequency Distribution
Frequency References
QUANTUM™ Atomic Oscillators
NTP Servers
Bus Level Timing
IEEE 1588 PTP Solutions
Test and Measurement
Global Services
Products A-Z
SUPPORT
Overview
Online Technical Support
FAQs
Technical Phone Support
Warranty & Repair
Global Services Divisions
NEWS & EVENTS
Press Releases
Events
Press Coverage
Articles
Awards
Webinars
COMPANY INFORMATION
About Us
Management Team
Board of Directors
SyncWorld Ecosystem Program
Careers
How to Buy
Contact Us
MY ACCOUNT
Login
Register
Order Status
Get A Quote
Partners
Subscribe
© Symmetricom. All Rights Reserved  |   Privacy Policy  |   Legal  |   Terms of Use
Home  |   Site Map  |   Get Connected: